Stainless steel rod end joint bearing SA16T/K
Stainless steel rod end joint bearing is spherical sliding bearing, the basic type is composed of inner and outer rings with spherical sliding spherical contact surface. The joint bearing is mainly composed of an inner ring with an outer sphere and an outer ring with an inner sphere, which can bear large loads. According to its different types and structures, it can bear radial load, axial load or combined load that exists simultaneously in radial and axial direction. Because the outer sphere of the inner ring is inlaid with composite material, the bearing can produce self-lubrication in operation. Generally used for low speed swing motion, but also in a certain Angle range for tilt motion, when the supporting shaft and shaft shell hole are not concentric, still can work normally. Self-lubricating joint auxiliary should be used for water conservancy, professional machinery and other industries. Because the spherical sliding contact area of the joint bearing is large, the tilt Angle is large, and because most of the joint bearing has taken special processing methods, such as surface phosphating, galvanized, chrome plating or external sliding surface lining, inlaying, spraying, etc. Therefore, it has larger load capacity and impact resistance capacity, and has the characteristics of corrosion resistance, wear resistance, self-aligning, good lubrication or self-lubrication without lubrication contamination, even if the installation dislocation can work normally. As a result, articular bearings are widely used for low velocity swing, tilt, and rotary motions. Spherical plain bearings and rod end articular bearings are available in a variety of designs and have different combinations of sliding contact surfaces. Each design and combination has unique performance that makes it particularly suitable for certain applications.
Stainless steel rod end joint bearing temperature, generally have rod end joint bearing outside surface temperature can be inferred, if using oil hole can directly measure the rod end joint bearing outer ring temperature, it is more appropriate. Generally, the temperature of stainless steel rod end joint bearing begins to rise slowly with the operation of rod end joint bearing, and reaches a stable state after 1-2 hours. The normal temperature of stainless steel rod end joint bearing varies with the heat capacity, heat dissipation, speed and load of the machine. If the lubrication, installation, stainless steel rod end joint bearing temperature will rise sharply, will appear abnormal high temperature, then must stop operation, take necessary precautions. The use of heat sensor can monitor the working temperature of the joint bearing at the rod end at any time, and realize the automatic alarm or stop when the temperature exceeds the specified value to prevent shaft burning accidents.